K38
K38 is a single acting rod seal with symetrical lips and an additional sealing lip which improves the leakage behaviour and at the same time, prevents the entry of dirt from the wiper side.
- Superior sealing effect with the secondary lipLow axial housing heights
- Secondary sealing lip provides extra protection against theingress of dirt particles
- Easy assembly into closed grooves
- Good sealing performance even at low pressures
- Wide range of dimensions
Construction machinery, fork-lift trucks, injection
mouldingmachines, Agricultural machinery, mobile
hydraulics, standardcylinders, loading platforms and
telescopic cylinders.
Easily assembled into closed grooves according to the minimum diameter values that are given in the below table. Open grooves or special assembly tools should be used for the values that are outside this table. Before installation the sealing element must be oiled with system oil.
K35 type of rod seal can be also used with double lip wipers. For special applications that require high temperatures or resistance to chemicals, piston seal is being manufactured with special mixture PTFE and FKM material. For heavy duty applications and high pressures the tolerances should change to H8/f8 and please contact the customer service to choose the suitable sealing element. The permissible sealing gap values of K35 rod seal is given in the below table.
Material | Code |
PU 94 SHORE A | PU9401 |
Surface roughness | Ra | Rmax |
Sliding Surface Ød | ≤0.4 μm | ≤3.2 μm |
Groove Base ØD | ≤1.6 μm | ≤10 μm |
Groove Flanks | ≤3.2 μm | ≤16 μm |
Permissible sealing gap
Smax (mm) | |||
t=(D-d)/2 (mm) | 150 bar | 250 bar | 400 bar |
t≤5 | 0.30 | 0.20 | 0.15 |
t>5 | 0.35 | 0.25 | 0.20 |
OPERATING CONTITIONS
Media | Mineral oils (DIN 51524) | HFA HFB | HFC |
Temperature | -30 °C +100 °C | +5 °C +50 °C | -30 °C +40 °C |
Pressure | ≤400 bar | ≤400 bar | ≤400 bar |
Speed | ≤0.5 m/sec | ≤0.5 m/sec | ≤0.5 m/sec |
Minimum diameter values for closed type of grooves
(D-d)/2 (mm) | 4 | 5 | 6 | 7.7 | 10 | 12.5 | 15 |
d min (mm) | 25 | 30 | 40 | 50 | 80 | 100 | 105 |